ЛР-А001-Б Тестер индекса протока талине на додирном екрану МФР МВР тест
- Опис
- Упит
Опис
ЛР-А001-Б Тестер индекса протока талине на додирном екрану МФР МВР тест
Discription:
Used for testing all kinds of plastic, resin in the state of viscous flow through a certain temperature and load, every 10 min module and melt flow rate through the standard port MFR value, it is suitable for high temperature of polycarbonate, aromatic sulfone, флуорна пластика, најлон и друге инжењерске пластике, може се применити и на полиетилен (ПЕ), polystyrene (PS), polypropylene (PP), ABS resin, polyformaldehyde (POM), polycarbonate (ПЦ) resin with lower melting temperature, као што је пластични тест, широко се користи у производњи пластике, пластични производи, such as petroleum and chemical industry and related colleges and universities, научноистраживачке јединице, and the commodity inspection department.
Standard:
GB/T3682-2000 《Determination of melt flow rate and melt volume flow rate of thermoplastics》
ИСО 1133:1997《Determination of melt flow rate and melt volume flow rate of thermoplastics》
ASTM D1238 《Standard Test Method for Determination of flow rate of Thermoplastic Melt by extruded plasticizer》
Test Methods:MFR+MVR Methods
ЛР-А001-Б Тестер индекса протока талине на додирном екрану МФР МВР тест
Режим приказа: 7-inch touch screen controller
Модел | LR-A001-B |
Barrel parameters | Inner hole 9.55±0.025mm |
Pistons parameters | Piston head: 9.475±0.015mm |
Outlet length | 8.000±0.025mm |
Paramters | Extrusion hole 1=2.095±0.005mm |
Temperature parameter | With intelligent temperature control instrument, with four pairs of significant temperature setting control, PID parameters can be automatically set, precision up to ± 0.1 degree centigrade |
Распон температуре | Room Temperature~450degree centigrade |
Temperature fluctuation | ±0.2 ℃ |
Temperature uniformity | ±1℃ |
Temperature display resolution | 0.1℃ |
Display resolution | 0.1℃ |
Maximum comsuption | < 600В |
Time display resolution | 0.1с |
Weight parameters are as follows: | |
Weight accuracy | ±0,5% |
Basic configuration
| A 0.325kg |
B 1.2kg | |
C 2.16kg | |
D 3.8kg | |
E 5kg | |
F 10kg | |
G 12.5kg | |
H 21.6kg | |
Position detection | |
Loop distance from up and down | 30мм |
Control precision | ± 0.1mm |
Test flow control | |
Times of cutting the material | 0~10 times |
Material cutting interval | 0~999s(set reference Table 2) |
Control flow reaches the set temperature without volatility | |
Barrel temperature time | 15 мин. |
Material be installed | 1 мин. |
Material sample temperature recovery time | 4 мин. |
When binder set | 1мин |
Output mode | Micro-automatic print output |
Cut material methods | The hand automatic cut into one body |
Test load | Eight sets of weights |
Снага | AC220V±10% 50/60HZ |