آلة اختبار الاهتزاز تستخدم على نطاق واسع في الدفاع الوطني, طيران, الفضاء الجوي, مجال الاتصالات, إلكترونيات, سيارات, الأجهزة المنزلية, الأدوية وتغليف المواد الغذائية وغيرها من الصناعات المختبرية واختبار اهتزاز خط الإنتاج لعينات المنتج. يستخدم هذا النوع من المعدات للكشف عن الأخطاء المبكرة, محاكاة قدرة الاهتزازات الجيبية والعشوائية التي يتعرض لها المنتج أثناء التصنيع, حَشد, النقل والاستخدام, وتقييم مقاومة الاهتزاز, موثوقية وسلامة هيكلها.

Several details that should be paid attention to when using vibration testing machine:
1.The specimen must be rigidly installed on the test bench surface, otherwise it will produce resonance and waveform distortion, affecting the test effect of the specimen in the vibration process, do not disassemble, اذا كان ضروري, please stop first.
2.The test fixture must be used correctly and fixed to avoid personnel injury and equipment damage.
3.If any abnormal phenomenon occurs during use, stop the test immediately to avoid damage to the machine.
4.Do not touch the sensor when the system is running.
5.When working, do not put magnetic or non-magnetic objects (such as watches, إلخ.) close to the vibration generator.
6.In order to allow the power amplifier module and the platform to have sufficient cooling time, the power amplifier leakage circuit breaker must be disconnected after 7 ل 10 minutes of cooling after cutting off the signal.
7.Do not turn off the control box and the microcomputer power supply before turning off the power amplifier, otherwise the impact of the club and the vibration table will cause damage.

Vibration testing machine maintenance knowledge trilogy:
1.When the vibration testing machine is running, it is necessary to add lubricant to the movement shaft inside the equipment and the wide belt required for operation, so that the equipment can be effectively operated;
2.Equipment in the identification of whether the product can withstand this vibration environment capacity, there must be technical personnel in the surrounding supervision, so as not to be tested sample slip out will destroy the smoothness of the surface of the equipment box, gear oil needs to be cleaned regularly, and every six months need to be replaced; After the end of the test, it is necessary to clean it after cooling to maintain the cleanliness of the equipment.
3.In the test work, please try not to open the test chamber door, opening at high temperature may cause burns to the operator, and opening at low temperature may cause frostbite to the staff in the early morning, and may cause the evaporator to freeze, which directly affects the refrigeration effect.