Abstract
This specification covers enhanced (Type I) and conventional (type II) paper adhesive tapes for securing and binding paper products and sealing fiberboard boxes. Type I adhesive tape can be stripped (class 1) or not stripped (class 2), while Type II paper adhesive tape, whether it is class A (light load), class B (medium load) or class C (heavy load) can not be stripped. The tape should be made of kraft paper, but it is also recommended to use recycled pulp in the paper, and the adhesive used must not have an offensive odor, and should comply with the specified environmental precautions. Type I tape should consist of two rolls of paper, while Type II tape should consist of one roll of paper. When produced, tape should be clean and free of folds, sharp creases, tears, cuts and holes. The tape should be checked for appearance defects, roller structure defects and dimensional defects. Tests for adhesion, tensile strength and elongation should also be carried out and should conform to specified physical properties.

This summary is a brief summary of the reference standards. It is informational only and not a formal part of the standard; The full text of the standard itself needs to be used and applied for reference. ASTM provides no warranties, express or implied, and does not represent that the content of this abstract is accurate, complete, or new.

Step 1: Scope
1.1 This specification covers ordinary and reinforced paper adhesive tapes for fixing and binding paper products and for sealing fiberboard boxes.

1.2 This regulation is intended to replace the Federal Reserve. Glasses. Part of CID AA-1492, CID AA-1671 and PPP-T-45.

1.3 Values expressed in SI units shall be regarded as standard values. The values given in parentheses are for reference only.

1.4 The following safety hazard warnings apply only to Section 11 “Test Methods” of this specification: This standard is not intended to address all safety hazards associated with use. It is the responsibility of the user of this standard to establish appropriate safety and health measures prior to use and to determine the applicability of regulatory restrictions.

1.5 This international standard is based on internationally recognized standardization principles established in the Decision on Principles for the Development of International Standards, Guidelines and Recommendations issued by the WTO Technical Barriers to Trade (TBT) Committee.

ASTM D5749-2017 Standard Specification for Reinforced and Ordinary Tape for Sealing and Fixing

2. Refer to the file
ASTM standard

D685 Conditions for inspection of paper and paper products

D828 Test method for tensile properties of paper and paperboard using constant elongation equipment

D996 Packaging and distribution environmental terms

D1974 / D1974M Practice of methods for sealing, sealing and reinforcing fiberboard boxes

D3951 Commercial packaging specification