Kahulugan at Layunin
4.1 The procedures described in this practice are intended to help evaluate the performance of house and decorative paints on new, previously unpainted wood.

4.2 Due to differences in solar radiation, wet time, temperatura, mga contaminants, at iba pang mga kadahilanan, the relative durability of paint during outdoor exposure may vary considerably depending on the location of the exposure. Kaya nga, it cannot be assumed that the results of a single exposure at a single location will help determine the relative durability of different locations. Exposure is recommended at multiple sites with different climates that represent a wide range of expected service conditions.

4.2.1 Due to annual climate variability, the results of a single exposure test cannot be used to predict the absolute rate of material degradation. It takes several years of repeated exposure to obtain an “average” test result for a given location.

4.2.2 Solar radiation varies greatly with the time of year. This can lead to large differences in apparent degradation rates for many coatings. It is not recommended to compare results for materials exposed for a short period of time (less than one year) unless the materials were exposed at the same location at the same time.

4.2.3 It is recommended to conduct at least three repeated tests for each material. Based on the parameters of the known material, a statistical estimate of the number of required repetitions can be found in Practice E122.

4.3 The Meaning and Uses section in Practice G7 addresses many of the variables to be considered in external exposure testing.

ASTM D 1006-2021 “Outdoor Exposure Test for Paint on Wood”

Saklaw ng
1.1 This practice covers the procedures to be followed for direct exposure of previously unpainted wood and wood composites to house and decorative paints. When the sponsor actual exposure of the aging test is carried out by a separate agency, the specific conditions for testing and controlling the exposure of the specimen should be clearly defined and mutually agreed upon by the parties.

1.2 This standard covers sample preparation, including the application of test coatings to wood substrates.

1.3 Values expressed in SI units or inch-pound units should be treated separately as standard values. The values specified in each system are not necessarily the same; Kaya nga, to ensure compliance with the standards, each system should be used independently of each other and the values of the two systems should not be combined.

1.4 Ang pamantayang ito ay hindi nilayon upang matugunan ang lahat ng mga isyu sa kaligtasan, kung meron man, na nauugnay sa paggamit nito. Responsibilidad ng gumagamit ng pamantayang ito na magtatag ng angkop na kaligtasan, mga kasanayan sa kalusugan at kapaligiran at upang matukoy ang pagiging angkop ng mga paghihigpit sa regulasyon bago gamitin.

1.5 Ang internasyonal na Pamantayang ito ay binuo alinsunod sa mga internasyonal na kinikilalang prinsipyo ng standardisasyon na itinatag sa Desisyon sa mga Prinsipyo para sa Pag unlad ng Internasyonal na Pamantayan, Mga Patnubay at Rekomendasyon na inilabas ng Komite sa mga Teknikal na Hadlang sa Kalakalan ng World Trade Organization.