Tape Initial Tack Tester/Adhesive tape tester
- תיאור
- חֲקִירָה
תיאור
Tape Initial Tack Tester/Adhesive tape tester
היקף היישום
The PT-502Tape Initial Tack Tester is suitable for the initial viscosity test of adhesive tapes, protective films, labels, plasters and other products to detect the adhesion performance of the object in short contact with the product to be tested.
Tape Initial Tack Tester/Adhesive tape tester
פרמטרים טכניים
Mesa width | 110מ"מ |
Try zone width | 70מ"מ |
Installation dimensions | (L*W*H) 320*140*180מ"מ |
Heavy volume | About 6 ק"ג |
The standard configuration | Main engine + steel ball 1 box + tweezers |
Roll the ball | Bearing steel |
Tilt Angle | 25° ~ 45°(מתכוונן) |
The ball size | 1/32 inch to 1 אִינְטשׁ |
Inclined plate | 4mm float glass |
runway | 100mm roll ball size |
Tape Initial Tack Tester/Adhesive tape tester
עומדים בסטנדרטים:
GB 4852 Test Method for initial viscosity of pressure-sensitive adhesive tapes
Test Method for JIS Z0237 Pressure-sensitive adhesive tapes and Pressure-sensitive adhesive sheets
Tape Initial Tack Tester/Adhesive tape tester
advantage
Safety design: The tilt plate is made of 4mm impact-resistant toughened glass;65° polishing process is adopted for the edge Angle to prevent hand cutting.
Material selection youdao: the instrument’s aluminum material accounts for up to 80%, so the choice of aluminum material is particularly important. The imported aluminum alloy is used as the raw material, which has advantages such as high tensile strength, no deformation after processing, and compact surface without defects.
Smooth rotation: Two imported bearings are used as sliding support on both sides of the rotating shaft, making the adjustment of the inclined plate more smooth and more accurate.
זווית מתכווננת: Angle indicator plate adopts acrylic screen printing process, the Angle is clear and easy to see;The indicator needle adopts 304 stainless steel wire cutting process, the tip of the round corner processing, anti-injury, clear instructions.
Balance control: The bottom of the instrument is set around the horizontal adjustment foot, while observing the horizontal bubble on the bottom plate, while adjusting the foot, the horizontal adjustment of the instrument can be realized.
Longer service life: all aluminum parts of the instrument are processed by multi-layer oxidation treatment process, which can greatly improve its corrosion resistance and wear resistance, thus achieving a longer service life.