1. Tujuan:

Untuk memastikan bahwa kualitas produk dapat memenuhi kebutuhan pelanggan, and make the appearance inspection of products can be based on the consistency of inspection standards, specially formulated.

2. Cakupan:

All the company’s paint products are applicable.

3. Definisi:

3.1. Side A:

The surface observed from the front after the product is installed.

3.2. Side B:

After the product is installed, the observer must rotate 90 degrees horizontally from side to side to be able to see the surface, itu adalah, the left and right sides of the product.

3.3.Side C:

After the installation of the product, the surface that is not easy to see by the observer, itu adalah, the bottom or back of the product.

ASTM D412-0 “Spesifikasi Pemeriksaan Penampilan Cat Kue suatu Perusahaan”

3.4. Perbedaan Warna:

Refers to the phenomenon of different shades of color for products of the same color.

3.5 Impurities:

The surface of the paint is more obvious convex attachment, rough touch

3.6 Adhesi:

Peeling of a lacquer from underneath or between materials.

3.7 Scratches:

The surface of the lacquer is scratched by a sharp object and the lacquer is exposed to the substrate.

ASTM D412-0 “Spesifikasi Pemeriksaan Penampilan Cat Kue suatu Perusahaan”

4. Inspection conditions:

4.1. Under the condition of 40W fluorescent lamp, the product is about 80cm away from the light source;

4.2. The inspector puts on gloves, holds the product, and the distance between the product is 30cm or an extended arm distance. The inspector can inspect the product visually without any amplification instrument;

4.3. Three-second rule for inspection: itu adalah, under the above inspection conditions, visually inspect the same side and place for 3 detik (referring to a defect, rather than the time taken to inspect the whole product);

5. Inspection standards

5.1. Material Inspection Standard:

ASTM D412-0 “Spesifikasi Pemeriksaan Penampilan Cat Kue suatu Perusahaan”

5.2. Inspection Standard of baking Paint: