ISO 1419:2019 is a standard that regulates accelerated aging tests for rubber – or plastic-coated fabrics. The purpose of this standard is to provide a standardized method for testing the resistance of rubber or plastic coated fabrics to accelerated aging caused by high temperature and humidity.

The standard specifies two methods for conducting accelerated burn-in tests: Method A, which involves exposure to high temperature and humidity in a controlled environment, and Method B, which involves exposure to an automatic sterilizer in high-pressure steam. Both methods are designed to simulate the effects of environmental conditions on long-term exposure to rubber or plastic coated fabrics.

This standard specifies test conditions, including temperature, humidity and exposure time requirements. It also provides guidance on the preparation of test samples and evaluation of test results.

ISO 1419:2019 applies to manufacturers and users of rubber or plastic coated fabrics to assess the durability and performance of their products. By conducting accelerated aging tests according to this standard, manufacturers can ensure that their products meet the requirements of intended applications and users can trust the durability and longevity of the products they purchase.

ISO 1419-2019 Rubber – or plastic-coated fabrics – Accelerated Ageing Tests

introduce
Aging of coated fabrics involves subjecting specimens with previously determined properties to controlled deterioration over a known period of time. Choosing the most appropriate test method, aging time and temperature will depend on the purpose of the test and the type of coated fabric. The properties used to measure deterioration of the coated fabric may be strength properties, bending, resistance, or any other desired physical or chemical properties. Its characteristics can be studied by selecting appropriate test methods.

Caution Persons using this document should be familiar with normal laboratory practice. This document is not intended to address all security concerns, if any, associated with its use. It is the user’s responsibility to establish appropriate safety and health practices and ensure compliance with any national regulatory conditions.

1 range
This document describes four methods for assessing the resistance of coated fabrics to accelerated aging degradation.

2 Normative references
All or part of the following documents are referred to normatively in this document and are not available for their use. For dated references, citation-only versions apply. For undated references, the latest version of the reference (including any revisions) applies.

ISO 188, vulcanized or thermoplastic rubber — accelerated ageing and heat resistance test

ISO 2231, rubber – or plastic-coated fabrics — Standard atmospheres for conditioning and testing

ISO 2286-1, rubber – or plastic-coated fabrics – Determination of roll characteristics – Part 1: Method of determination of length, width and net mass

ISO 2286-2, rubber – or plastic-coated fabrics – Determination of roll characteristics – Part 2: Method of determination of total mass per unit area, mass per unit of coating and mass of substrate per unit area