ASTM D 5895-2020 “기계식 기록 장치를 이용한 필름 형성 중 유기 코팅의 건조 또는 유착 평가”

의미와 목적
5.1 The drying time of the coating is important to determine when it is possible to re-use a newly painted room, floor or staircase or to dispose of or package coated items. Slow drying may lead to dirt contamination or, on the exterior surface, 습기로 인해 외관이 고르지 않을 수 있습니다..

5.2 These test methods are used to determine the various stages of drying or curing during dry film formation of organic coatings using mechanical equipment to compare coating types or compositional changes, 아니면 둘다. To quantitatively assess the drying phase, the use of instruments under environmentally controlled conditions is highly recommended. These devices also provide a way to determine the drying characteristics of the coating that cannot be determined within a standard 8-hour working day.

5.3 When evaluating the drying characteristics of the baking system, the cyclic drying time equipment provides a method to determine the quantitative drying time of the coating at room temperature and high temperature conditions. The maximum temperature will be limited by factors such as the effect of temperature on motor lubrication or structural components of the equipment.

5.4 Linear drying time equipment provides a means of using a recorder to determine the quantitative drying time of simultaneously tested coatings.

5.5 This method can be used to compare the behavior of coatings during drying of the same general type. The actual drying time should be determined in accordance with the procedures outlined in Test Method D1640 or ISO 9117-3.

ASTM D 5895-2020 “기계식 기록 장치를 이용한 필름 형성 중 유기 코팅의 건조 또는 유착 평가”

범위
1.1 These test methods describe the determination of several stages and dry film formation rates of organic coatings using linear and circular mechanical drying time recording devices. The use of a mechanical recorder is valuable for comparing the drying behavior of the same generic type of coating, allowing one coating to form gel or resist tearing at a faster rate than another.

1.2 Drying times measured using mechanical recorders may differ from those using conventional methods such as test method D1640 or ISO 9117-3 (formerly known as ISO 1517).

1.3 The values specified in SI shall be regarded as standards. 괄호 안의 값은 참고용입니다..

1.4 이 표준은 모든 안전 문제를 다루기 위한 것이 아닙니다., 만약에 어떠한, 그 사용과 관련된. 적절한 안전을 확립하는 것은 이 표준 사용자의 책임입니다., 건강 및 환경 관행을 확인하고 사용 전 규제 제한의 적용 여부를 결정합니다..

1.5 본 국제 표준은 국제 표준 개발 원칙에 관한 결정에서 확립된 국제적으로 인정받는 표준화 원칙에 따라 개발되었습니다., 세계무역기구(WTO) 무역기술장벽위원회가 발행한 지침 및 권고사항.

이 게시물을 공유하세요