의미와 목적
3.1 이 테스트 방법은 자유 필름 측정에 특히 적합합니다., and also suitable for the measurement of films on laboratory test plates.

3.2 The accuracy and accuracy of the thickness measurement may be affected by the deformation ability of the coating. This test method is not applicable to coatings that are prone to deformation under the load of the measuring instrument.

3.3 When the coating is applied to laboratory test plates, the accuracy and accuracy of the thickness measurement is also affected by the uniformity of the substrate.

범위
1.1 This test method includes the use of a micrometer to measure the dry film thickness of paint, varnisher, lacquer and related products. Programs A and B used fixed micrometers, and programs C and D used handheld micrometers. Procedures A and C are not recommended for films less than 12.5 μm (0.5 mille) in thickness. The minimum thickness required for procedures B and D is a function of the minimum thickness required to be able to remove the sample as a free film.

1.2 The following procedures appear:

1.2.1 Procedure A — Fixed micrometer for measuring flat rigid surface coatings.

1.2.2 Procedure B — Fixed micrometer for measuring free film.

1.2.3 Program C — Handheld micrometer for measuring coatings on flat rigid surfaces.

1.2.4 Program D — Handheld micrometer for measuring free films.

1.3 Values expressed in SI units shall prevail. 괄호 안의 값은 참고용입니다..

ASTM D1005-95-2020 마이크로미터를 사용하여 유기 코팅의 건조 필름 두께를 측정하기 위한 표준 테스트 방법

1.4 이 표준은 모든 안전 문제를 다루기 위한 것이 아닙니다., 만약에 어떠한, 그 사용과 관련된. 적절한 안전을 확립하는 것은 이 표준 사용자의 책임입니다., 건강 및 환경 관행을 확인하고 사용 전 규제 제한의 적용 여부를 결정합니다..

1.5 This international Standard has been developed in accordance with the internationally accepted standardization principles established in the Decision on Principles for the Development of International Standards, 무역 기술 장벽이 발행한 지침 및 권장 사항 (TBT) 세계무역기구 위원회.