ASTM D2809-2017 “Oznaczanie korozji wnęki pompy aluminiowej i korozji erozyjnej płynu chłodzącego silnik”

Znaczenie i zastosowanie
4.1 This test method can be used to distinguish between coolants that cause cavitation and erosive corrosion of aluminum automotive pumps and those that do not. Specific rating numbers determined based on this test are not intended to correspond to specific mileage in vehicle testing; Jednakże, limited correlation was observed between bench and field service tests using single-phase coolant. If the actual impact of coolant on cavitation and erosive corrosion is to be assessed, field testing under harsh operating conditions should be used as the final test. With proper control of the test variables, it is also possible to determine the influence of pump design, structural materials, and pump operating conditions on cavitation and erosion corrosion damage.

ASTM D2809-2017 “Oznaczanie korozji wnęki pompy aluminiowej i korozji erozyjnej płynu chłodzącego silnik”

Promień
1.1 This test method covers the evaluation of cavitation and erosion corrosion characteristics of aluminum automotive pumps with coolant.

Notatka 1: During the development of this test method, it was found that the results obtained when testing two-phase coolants were not correlated with the results of field tests. Dlatego, this test method cannot be recommended as an important test for determining cavitation effects of two-phase coolants.

1.2 Wartości wyrażone w jednostkach SI należy uważać za wartości standardowe. Wartości podane w nawiasach po jednostce SI służą wyłącznie celom informacyjnym i nie są uważane za wartości standardowe.

1.3 Niniejsza norma nie ma na celu rozwiązania wszystkich problemów związanych z bezpieczeństwem, Jeśli w ogóle, związane z jego użytkowaniem. Obowiązkiem użytkowników tej normy jest zapewnienie odpowiedniego bezpieczeństwa, praktyk zdrowotnych i środowiskowych oraz w celu określenia możliwości zastosowania ograniczeń regulacyjnych przed użyciem. Widzieć 5.2 for specific warning statements.

1.4 Niniejsza norma międzynarodowa opiera się na uznanych na arenie międzynarodowej zasadach normalizacji, ustanowionych w Decyzji w sprawie zasad opracowywania norm międzynarodowych, Wytyczne i zalecenia wydane przez Komitet WTO ds. Barier Technicznych w Handlu.

Podziel się tym postem