Description

1.Measurement Range：   0—1250um or 0—50mil

2. Accuracy：± [(1%~3%)H+1um]  Note：H is thickness reading
3. powers down after 60 seconds of no activity.

   1、Power-on
   Keystroke once；Wait until  READY！ is displayed on the LCD. Now the gauge is ready for measurements.
   2、Zeroing
   Keystroke twice; when  BASE ZERO  is displayed, place flat on surface; hold steady. After measurement is obtained,  DONE  is shown and gauge beeps. Then lift gauge.
   Note: Please conduct zeroing process after changing base. Zeroing process could be repeated for better results.
   3、Two-Point User Calibration
   Keystroke three times, enter into the process of tow-point user calibration; when
   USER CAL BASE  is shown on the LCD, please conduct a measurement on the base first; when
   S1  is shown on the LCD, place Shim S1 on the base, conduct a measurement on shim S1 and lift gauge; when
   S2  is shown on the LCD, place Shim S2 on the base, conduct a measurement on shim S2 and lift gauge; When  DONE  is displayed, it is ready for use.
   Note: The two-point user calibration process could be repeated for better results.
   4、Unit Change
   Keystroke four times, convert from ums to mils or vice versa.
   5、Reset
   Keystroke five times, gauge resets.