АСТМ Д 3361-2020 “Испытание на воздействие угольной дуги нефильтрованным пламенем на краски и соответствующие покрытия”

Значение и цель
4.1 Для многих приложений, the ability of a paint or coating to resist deterioration of physical and optical properties due to exposure to light, нагревать, and water may be very important. This practice aims to cause changes in attributes related to end-use conditions, включая воздействие солнечного света, влага, и тепло. The exposures used in this practice are not intended to model the deterioration caused by local weather phenomena such as atmospheric pollution, биологическая атака, and saline-water exposure.

4.2 CaveatsResults may change when different operating conditions are used. Поэтому, no reference to the use of this practice may be made unless accompanied by a report prepared under Section 10 описание конкретных условий эксплуатации, используемых. See Practice G151 for details of the caveats applicable to the use of the results obtained under this practice.

Примечание 1: Дополнительную информацию об источниках изменчивости и стратегиях устранения изменчивости в проекте см., исполнение, и анализ данных лабораторных испытаний ускоренного воздействия, см. Руководство G141.

4.2.1 The spectral power profiles of light from unfiltered open flame carbon arcs are significantly different from those generated by light and water exposure devices using other carbon arc configurations or other light sources. The type and rate of degradation and performance ranking resulting from exposure to unfiltered open flame carbon arcs may be quite different from those resulting from exposure to other types of laboratory light sources. В общем, exposure in accordance with this protocol will produce degradation more rapidly than similar exposure in accordance with practice D822/D822M or D5031/D5031M and may result in different types of degradation.

4.2.2 Inter-laboratory comparisons are valid only if all laboratories use the same type of carbon arc and exposure conditions.

АСТМ Д 3361-2020 “Испытание на воздействие угольной дуги нефильтрованным пламенем на краски и соответствующие покрытия”

4.3 The reproducibility of test results between laboratories has been shown to be good when evaluating the stability of the material according to the performance class compared to other materials or controls. Ив,5 Поэтому, it is highly recommended to expose similar materials with known properties (контроль) одновременно с испытуемым материалом. At least three replications of each material are recommended to allow statistical evaluation of the results.

4.4 Test results will depend on the degree of care with which the equipment is operated in accordance with Practice G152. Важные факторы включают регулирование линейного напряжения., отсутствие солей и других водных отложений, контроль температуры и влажности, and electrode conditions.

4.5 All exposures referred to in accordance with this practice shall include a complete description of the test period used.

Объем
1.1 This specification covers the selection of test conditions for accelerated exposure testing of coatings and related products in unfiltered open-flame carbon arc installations in accordance with regulations G151 and G152. The practice also includes preparation of specimens, suitable test conditions for coatings, и оценка результатов испытаний.

1.2 This practice covers the unfiltered open-flame carbon arc exposure of paints and associated coatings and covers the exposure period commonly referred to as thedew cycle”. Practice D822/D822M describes the filtered open flame carbon arc device and Practice D5031/D5031M describes the closed carbon arc exposure. Radiation from unfiltered open flame carbon arcs produces shorter wavelengths and higher levels of shortwaver radiation compared to filtered open flame or closed carbon arcs.

АСТМ Д 3361-2020 “Испытание на воздействие угольной дуги нефильтрованным пламенем на краски и соответствующие покрытия”

1.3 Values expressed in SI units or inch-pound units should be treated separately as standard values. Значения, указанные в каждой системе, не обязательно совпадают.; Поэтому, обеспечить соблюдение стандартов, каждую систему следует использовать независимо друг от друга, и значения двух систем не следует объединять..

1.4 Настоящий стандарт не предназначен для решения всех вопросов безопасности., если таковые имеются, связанный с его использованием. Пользователь настоящего стандарта несет ответственность за установление соответствующей безопасности., практики в области здравоохранения и окружающей среды, а также для определения применимости нормативных ограничений перед использованием..

1.5 Настоящий международный стандарт был разработан в соответствии с международно признанными принципами стандартизации, установленными в Решении о принципах разработки международных стандартов., Руководящие принципы и рекомендации, выпущенные Комитетом по техническим барьерам в торговле Всемирной торговой организации.

Поделиться этой записью