АСТМ Д6625- Испытание характеристик защиты от полировки окрашенных панелей с использованием флуоресцентного ультрафиолетового конденсационного света и устройств воздействия воды – Describes the procedure required to evaluate the protective performance of polished films by ultraviolet irradiation, нагревать, и влага. Unlike ASTM G155 and ISO 4892-4 практики, whose lighting sources are xenon lamps and carbon arcs, соответственно, this test protocol relies on the use of fluorescent ultraviolet rays. The method is therefore based on the principles of the ASTM G154 standard.

Evaluate polishing behavior by accelerating weathering use and taking into account:

ASTM D6625-0 Стандартная практика тестирования защитных свойств полиролей, нанесенных на окрашенные платы, с использованием флуоресцентного УФ-конденсирующего света и устройств воздействия воды

The goal of ASTM D6625 is to evaluate the ability of polishes to protect against degradation caused by heat, UV light exposure, and humidity through the use of accelerated aging tests. The latter involves exposing samples within the device to water condensation, ultraviolet radiation and temperature changes up to a predetermined amount of time as a means of simulating decay caused by water and sunlight. This property is determined by periodic gloss readings of the polished and unpolished areas of the sample. Кроме того, this periodic assessment allows the evolution of the property to be monitored. К сожалению, the method does not provide a correlation that can be used to predict the outdoor performance of the sample. С другой стороны,

The main factor to consider when running this test is: the amount of polish used on the sample.

Typical test parameters for ASTM D6625:

The number and size of samples need to be specified. The test specifications are listed in Table 1.

ASTM D6625-0 Стандартная практика тестирования защитных свойств полиролей, нанесенных на окрашенные платы, с использованием флуоресцентного УФ-конденсирующего света и устройств воздействия воды