Значение и цель
5.1 Этот метод испытаний представляет собой структурированную процедуру для определения уровня опасности стекла., glass systems and glass retrofit systems subjected to air explosion loads. Knowing the hazard level allows assessing the risk of personal injury and damage to facilities.

5.2 glass or glass material level does not mean that the danger of a single sample can resist its rating of 1.0 specific air blast. The probability that an individual glass or glass building specimen resists its rated specific air explosion increases in proportion to the number of specimens that successfully resist a given air explosion level up to its rated hazard level.

ASTM F1642-2017 Стандартный метод испытаний дверных и оконных стекол и систем сборки стекла под нагрузкой воздушного потока

Объем
1.1 This test method specifies procedures for assessing the hazard of glass or glass systems to air explosive loads. The designated organization shall provide the air explosion load parameters. The glass system shall be as defined in Specification F2912.

1.2 from the method of the data obtained from the test is applied to use standard F2912 sure glass or glass, glass system transformation system risk level.

1.3 this test method allows with or without a frame system of glass for testing and rating.

1.4 the test method is designed to test and evaluation system of all glass, glass and glass systems, including but not limited to, made of glass, пластик, plastic cladding glass, sandwich glass, glass/plastic materials, organic coating glass and other are not directly connected to the glass or glass glass transformation system, such as explosion-proof, cable grid, shadows, and architecture.

1.5 Units-Values expressed in SI units or inch-pound units should be treated separately as standard values. Значения, указанные в каждой системе, могут быть не совсем эквивалентными.; Поэтому, каждая система должна использоваться независимо друг от друга. Merging values from both systems may result in non-compliance with the criteria. For the conversion of quantities in various measurement systems to SI units, see specification E699.

1.6 Настоящий стандарт не предназначен для решения всех вопросов безопасности., если таковые имеются, связанный с его использованием. Пользователь настоящего международного стандарта несет ответственность за установление соответствующих мер безопасности и гигиены труда., and determine regulations limit the applicability of before use. См. раздел 7 для описания конкретных опасностей.