ASTM B490-2014 Elektrodepozisyonla Süneklik Mikrometresi Bükme Testleri için Standart Uygulama

Anlamı ve kullanımı

4.1 Bu uygulama belirli elektrokaplama çözümlerini kontrol etme yöntemi olarak kullanılabilir.. It is used to indicate the presence of pollution or some other adverse condition.

4.2 Ductility measurement is of particular value when electroplated parts are subjected to moderate stresses, such as when electroplated bumpers are bolted to a car or exposed to a wide range of fluctuating temperatures (thermal shock).

ASTM B490-2014 Elektrodepozisyonla Süneklik Mikrometresi Bükme Testleri için Standart Uygulama

Adım 1: Kapsam

1.1 This practice describes procedures for measuring the ductility of electrodeposited foils. 2

1.2 This practice is only applicable to the evaluation of electrical deposits with low ductility.

1.3 The ductility value obtained can only be considered semi-quantitative because the test has a significant operator dependence.

1.4 This practice is most applicable to internal process control, where measurements are always taken by the same operator. Changes in the ductility value can be used as an indication of possible changes in an electroplating solution.

1.5 SI birimlerinde ifade edilen değerler standart değerler olarak kabul edilecektir.. Bu standartta başka hiçbir ölçü birimi yer almamaktadır..

1.6 This standard is not intended to address safety concerns, varsa, kullanımıyla ilgili. Uygun güvenlik ve sağlık uygulamalarını oluşturmak ve kullanımdan önce düzenleyici kısıtlamaların uygulanabilirliğini belirlemek bu standardı kullananların sorumluluğundadır..

Bu gönderiyi paylaş