描述

Pneumatic cutting and tester,Rubber pneumatic automatic cutting and tester
概述:
This pneumatic slicer is mainly used for rubber cutting standard test pieces, which should be connected with standard cutting die and more than 4KG air source.

Pneumatic cutting and tester,Rubber pneumatic automatic cutting and tester
技术参数:

Pneumatic cutting and tester,Rubber pneumatic automatic cutting and tester
Operation method:
1. Put the slicer on the plane, adjust the four footing to make it smooth, and put the cutting glue on it.
2. Open the air source, adjust the air valve switch of the oil-water separator behind, and adjust the barometer by at least 4KG
3. Put PU glue, put the film on the cutting glue, and then put the knife die, and then hold down the red press switch with both hands at the same time (for safety, both hands must press at the same time), press the press disc down to the knife die, stay for a few seconds, so that the rubber is fully cut, then let go at the same time, take out the test piece.
4. Please turn off the air source.

Pneumatic cutting and tester,Rubber pneumatic automatic cutting and tester
Operation method:
1. Put the slicer on the plane, adjust the four footing to make it smooth, and put the cutting glue on it.
2. Open the air source, adjust the air valve switch of the oil-water separator behind, and adjust the barometer by at least 4KG
3. Put PU glue, put the film on the cutting glue, and then put the knife die, and then hold down the red press switch with both hands at the same time (for safety, both hands must press at the same time), press the press disc down to the knife die, stay for a few seconds, so that the rubber is fully cut, then let go at the same time, take out the test piece.
4. Please turn off the air source.