Kahulugan at Layunin
4.1 due to the potential use of rigid cellular plastics are diverse, so the effective behavior of human exposure to estimate these materials need to a large extent based on the desired application. For this, the test method is designed to recommend a variety of conditions, select one or more required exposure conditions. (Tala 3)

4.2 The conditions recommended in this test method have been widely used to artificially expose rigid porous plastics and to determine the effects of various temperatures and humidity on these materials. The ultimate test measured value in determining sample after return to room temperature. In the specified case, samples will be tested under exposure conditions but will need to be reported.

4.3 through the test method for measuring the size of the changes can be used to compare the material performance in a specific environment, evaluation of two or more relative stability of porous plastic, or specify particular materials acceptance criteria. The results of this testing method are not suitable for predicting end-use product performance or characteristics and are not sufficient for engineering or design calculations.

ASTM D2126-2020 Standard Test Method for Thermal and Wet Aging Reactions of Rigid Foam Plastics

Tala 3: If a thermal shock is known or suspected to occur as a result of rapid heating to (or cooling from) a specific temperature, guidance should be obtained from the manufacturer of the material in question as to the allowable heating or cooling rate or both.

Tala 4: the size of the sample changes may be due to the age of the sample or sample preparation and testing began between the length of time or both.

4.4 Before performing this test method, reference should be made to the specifications of the material being tested. Material specification or its portfolio covers any sample preparation, adjustment, size or test parameters should be prior to this test method mentioned in the argument. If there is no specification, the default condition applies.

ASTM D2126-2020 Standard Test Method for Thermal and Wet Aging Reactions of Rigid Foam Plastics

Saklaw ng
1.1 The test method covers heat exposure and moisture exposure procedures for rigid porous plastics. The terms of use shall be agreed between the buyer and the supplier.

Tala 1: the list common exposure conditions are shown in table 1.

1.2 to SI units shall be deemed to be standard. The values in parentheses are for reference only.

1.3 Ang pamantayang ito ay hindi nilayon upang matugunan ang lahat ng mga isyu sa kaligtasan, kung meron man, na nauugnay sa paggamit nito. Responsibilidad ng gumagamit ng pamantayang ito na magtatag ng angkop na kaligtasan, mga kasanayan sa kalusugan at kapaligiran at upang matukoy ang pagiging angkop ng mga paghihigpit sa regulasyon bago gamitin.

Tala 2: this test method on sampling and part equivalent to ISO 2796. It is not equivalent to ISO 2796 in the procedures section.

1.4 Ang internasyonal na Pamantayang ito ay binuo alinsunod sa mga internasyonal na kinikilalang prinsipyo ng standardisasyon na itinatag sa Desisyon sa mga Prinsipyo para sa Pag unlad ng Internasyonal na Pamantayan, Mga Patnubay at Rekomendasyon na inilabas ng Komite sa mga Teknikal na Hadlang sa Kalakalan ng World Trade Organization.