Replacing the gasket of a high speed disperser usually requires the following steps:

Stop the dispersing machine: First of all, completely stop the dispersing machine, and ensure that the power has been cut off to ensure the safety of operation.

Remove the old gasket: Open the sealed part of the disperser, usually the seal cap or seal chamber. To remove the old gasket, you can use a tool such as a wrench or screwdriver to loosen the fastener and remove the gasket.

Clean the seal: Clean the seal and make sure there is no old gasket or dirt left. It can be cleaned with appropriate cleaners and cleaning tools to ensure that the sealed part is dry and clean.

Install new gasket: Install new gasket to seal section. Make sure the gaskets are properly aligned and not twisted or damaged. Depending on the design of the disperser, it may be necessary to use fasteners to hold the gasket in place.

How to change the gasket of high speed dispersing machine?

Adjust the seal: Depending on the requirements of the disperser, it may be necessary to adjust the position or pressure of the gasket. Please refer to the operating instructions of the dispersing machine or the instructions provided by the manufacturer to make corresponding adjustments.

Test and inspection: After installing the new gasket, restart the disperser and perform a test run. Make sure that the sealing part does not leak and that the sealing effect is good. Check for abnormal sounds, vibrations, or other problems.

Tip: If you are not clear about the specific model or details of the dispersion machine, it is recommended to refer to the operation manual of the dispersion machine or contact the manufacturer of the dispersion machine for detailed operation guidance and technical support.