ASTM D7539 Standard Practice for Humidity Regulation of Pavement Marking Coatings test Boards using a laboratory defines a standard environment with a temperature of 23±2°C, a relative humidity of 50± 5%, and no airflow for the normal regulation and testing of paints, pernis, lacquers, and related materials.
Arti dan kegunaannya

5.1 The drying rate of organic coatings varies with temperature, air flow and relative humidity. Secara khusus, the drying rate of water-based coatings depends on the evaporation of water and is therefore more dependent on relative humidity than solvent-based coatings or 100% solid coatings. Without some control over drying conditions, the drying rate of water-based coatings measured in the laboratory under ambient conditions cannot be adequately replicated. A test chamber providing a device for controlling relative humidity above ambient humidity and minimizing the effect of changes in airflow at ambient room temperature is described. If needed,

5.2 This practice is particularly useful for testing the drying rate of waterborne pavement marking (traffic) pelapis, where rapid drying at high ambient humidity is an important feature. For waterborne traffic coatings, test chambers can be used to assess dryness to non-absorption at high ambient humidity (test method D711) and washable resistance (practice D7377 and D7538).

ASTM D7539-2015 Praktik Standar untuk Pengaturan Kelembaban Papan Uji Pelapisan Marka Perkerasan Menggunakan Laboratorium

Melangkah 1: Cakupan

1.1 Specification D3924 defines a standard environment with a temperature of 23±2°C, a relative humidity of 50± 5% and no airflow for the normal conditioning and testing of paints, pernis, lacquers and related materials. The practice describes a test chamber that allows the control of relative humidity above the ambient relative humidity and minimizes air flow to regulate the test board at elevated relative humidity and room temperature.

1.2 Nilai dalam inci hingga pon harus dianggap sebagai nilai standar. Nilai yang diberikan dalam tanda kurung adalah transformasi matematis dari satuan SI dan hanya untuk referensi dan tidak dianggap standar.

1.3 Standar ini tidak dimaksudkan untuk mengatasi semua masalah keselamatan, jika ada, terkait dengan penggunaannya. Pengguna standar ini bertanggung jawab untuk menetapkan praktik keselamatan dan kesehatan yang sesuai dan menentukan penerapan pembatasan peraturan sebelum digunakan..