ASTM D 1640-2022: 건조, 경화, 실온에서 유기 코팅의 필름 형성 및 필름 형성

의미와 목적
3.1 이러한 테스트 방법을 사용하여 다양한 건조 단계와 속도를 결정할 수 있습니다., curing and film formation of organic coatings to compare coating types, to assess the effect of compositional changes on drying times, or to assess drying/curing times on the shop floor or in the field. Low temperatures can significantly slow down the drying rate of coatings, so it is often possible to use low-temperature curing agents, catalysts, and/or accelerators to aid in drying and film formation at cooler temperatures. Method B aims to assess these components and/or determine the effect of lower temperatures on drying rates. 거꾸로, the drying/curing rate of some coatings is accelerated under high temperature/humidity conditions, while others may be adversely affected by elevated humidity. Method C was designed to evaluate the effect of high temperature and relative humidity conditions on drying, curing and film formation of paints and coatings. The terms dry or dry, cured or cured, and film forming are used interchangeably throughout the standard.

3.2 Test Methods A, B and C are limited to comparing paints/coatings applied to smooth, non-absorptive substrates and do not reflect the effect of paint carrier absorption into substrates.

ASTM D 1640-2022: 건조, 경화, 실온에서 유기 코팅의 필름 형성 및 필름 형성

범위
1.1 These test methods cover the various stages and rates of film formation during drying or curing of organic coatings under laboratory controlled air temperature (낮은, ambient and/or elevated) and/or humidity conditions. Procedures for assessing drying under prevailing conditions of workshop and field temperature and humidity are also described.

1.2 SI 단위나 잉크파운드 단위로 표현된 값은 표준값으로 별도로 취급되어야 합니다.. 각 시스템에 지정된 값이 반드시 동일할 필요는 없습니다.; 그러므로, 표준 준수를 보장하기 위해, 각 시스템은 서로 독립적으로 사용해야 하며 두 시스템의 값을 결합해서는 안 됩니다..

ASTM D 1640-2022: 건조, 경화, 실온에서 유기 코팅의 필름 형성 및 필름 형성

1.3 이 표준은 모든 안전 문제를 다루기 위한 것이 아닙니다., 만약에 어떠한, 그 사용과 관련된. 적절한 안전을 확립하는 것은 이 표준 사용자의 책임입니다., 건강 및 환경 관행을 확인하고 사용 전 규제 제한의 적용 여부를 결정합니다..

1.4 본 국제 표준은 국제 표준 개발 원칙에 관한 결정에서 확립된 국제적으로 인정받는 표준화 원칙에 따라 개발되었습니다., 세계무역기구(WTO) 무역기술장벽위원회가 발행한 지침 및 권고사항.

이 게시물을 공유하세요