코팅 -4 cup viscosity test is a method used to determine the size of the viscosity of a sample such as paint under kinematic viscosity conditions. This test is suitable for samples with an outflow time between 10 그리고 150 초, and the viscosity is determined by the time the sample exits from a specified aperture at a specified temperature. This paper will introduce the test procedure, instrument and application method of the Tu-4 cup viscometer, as well as the related precautions and results.

기기 및 시약

The instruments required to perform the coating -4 cup viscosity test include coating -4 컵 점도계, tray balance, beaker, 온도계, 등. 게다가, diluting solvents and glass rods are required for the preparation and stirring of the test solution.

준비 작업

테스트를 진행하기 전에, you need to prepare the test fluid. 첫 번째, about 150mL of the test liquid is weighed in a beaker, and then 100g of the test substance is dissolved by stirring with a glass rod. If the measured substance needs to be diluted, it should be dissolved with the corresponding solvent and fully stirred to dissolve. 게다가, the coating -4 viscometer needs to be checked to ensure that there is no residual adhesion on its surface.

코팅 -4 컵 점도 테스트 절차, 도구 및 사용 방법

Procedure of use

Inject the test liquid into the viscometer, plug the outflow hole with your finger, and scrape the excess test liquid into the groove at the edge of the viscometer after filling.

Release the finger, the test liquid flows out vertically, start the stopwatch at the same time, stop the stopwatch when the test liquid flows out into a line shape and disconnects, and record the outflow time as the viscosity value.

테스트가 완료된 후, clean the viscometer with cotton dipped in the corresponding solvent to ensure cleanliness.

코팅 -4 컵 점도 테스트 절차, 도구 및 사용 방법

Result presentation and precautions

The test result is expressed as the arithmetic mean of the measured values of two parallel samples, and the difference between the two measured values of parallel tests is required to be no more than 3% 평균값의. 시험 중, it is necessary to pay attention to check the cleanliness of the Tu-4 viscometer to avoid residues affecting the test results. 게다가, the sample temperature is too high or too low will lead to viscosity error, should ensure that the sample is tested at the specified temperature.

참조 표준

The test method follows the national standard GB/T 1723 “Coating viscosity determination method”.

As an important method to evaluate the viscosity of coatings, the coating -4 cup viscosity test has wide application value in coating and other fields. The standardized operation and accuracy of the method ensure the reliability of the test results, and provide a strong support for the production and quality control of coatings.