Significado e Propósito
4.1 The procedures described in this practice are intended to help evaluate the performance of house and decorative paints on new, previously unpainted wood.

4.2 Devido às diferenças na radiação solar, wet time, temperatura, contaminantes, e outros fatores, the relative durability of paint during outdoor exposure may vary considerably depending on the location of the exposure. Portanto, it cannot be assumed that the results of a single exposure at a single location will help determine the relative durability of different locations. Exposure is recommended at multiple sites with different climates that represent a wide range of expected service conditions.

4.2.1 Due to annual climate variability, the results of a single exposure test cannot be used to predict the absolute rate of material degradation. It takes several years of repeated exposure to obtain an “média” test result for a given location.

4.2.2 Solar radiation varies greatly with the time of year. This can lead to large differences in apparent degradation rates for many coatings. It is not recommended to compare results for materials exposed for a short period of time (less than one year) unless the materials were exposed at the same location at the same time.

4.2.3 It is recommended to conduct at least three repeated tests for each material. Based on the parameters of the known material, a statistical estimate of the number of required repetitions can be found in Practice E122.

4.3 The Meaning and Uses section in Practice G7 addresses many of the variables to be considered in external exposure testing.

ASTM-D 1006-2021 “Teste de exposição externa para tinta em madeira”

Escopo de
1.1 This practice covers the procedures to be followed for direct exposure of previously unpainted wood and wood composites to house and decorative paints. When the sponsor actual exposure of the aging test is carried out by a separate agency, the specific conditions for testing and controlling the exposure of the specimen should be clearly defined and mutually agreed upon by the parties.

1.2 This standard covers sample preparation, including the application of test coatings to wood substrates.

1.3 Valores expressos em unidades SI ou unidades polegada-libra devem ser tratados separadamente como valores padrão. Os valores especificados em cada sistema não são necessariamente os mesmos; Portanto, para garantir o cumprimento das normas, cada sistema deve ser usado independentemente um do outro e os valores dos dois sistemas não devem ser combinados.

1.4 Esta norma não se destina a abordar todas as questões de segurança, caso existam, associado ao seu uso. É responsabilidade do usuário desta norma estabelecer medidas de segurança apropriadas, práticas de saúde e ambientais e para determinar a aplicabilidade de restrições regulatórias antes do uso.

1.5 Esta Norma internacional foi desenvolvida de acordo com os princípios de padronização internacionalmente reconhecidos estabelecidos na Decisão sobre Princípios para o Desenvolvimento de Normas Internacionais, Diretrizes e recomendações emitidas pelo Comitê sobre Barreiras Técnicas ao Comércio da Organização Mundial do Comércio.