Semnificație și scop
4.1 The procedures described in this practice are intended to help evaluate the performance of house and decorative paints on new, previously unpainted wood.

4.2 Datorită diferențelor de radiație solară, timp umed, temperatura, contaminanți, și alți factori, the relative durability of paint during outdoor exposure may vary considerably depending on the location of the exposure. Prin urmare, it cannot be assumed that the results of a single exposure at a single location will help determine the relative durability of different locations. Exposure is recommended at multiple sites with different climates that represent a wide range of expected service conditions.

4.2.1 Due to annual climate variability, the results of a single exposure test cannot be used to predict the absolute rate of material degradation. It takes several years of repeated exposure to obtain an “in medie” test result for a given location.

4.2.2 Solar radiation varies greatly with the time of year. This can lead to large differences in apparent degradation rates for many coatings. It is not recommended to compare results for materials exposed for a short period of time (less than one year) unless the materials were exposed at the same location at the same time.

4.2.3 It is recommended to conduct at least three repeated tests for each material. Based on the parameters of the known material, a statistical estimate of the number of required repetitions can be found in Practice E122.

4.3 The Meaning and Uses section in Practice G7 addresses many of the variables to be considered in external exposure testing.

ASTM D 1006-2021 “Test de expunere în aer liber pentru vopsea pe lemn”

Scopul
1.1 This practice covers the procedures to be followed for direct exposure of previously unpainted wood and wood composites to house and decorative paints. When the sponsor actual exposure of the aging test is carried out by a separate agency, the specific conditions for testing and controlling the exposure of the specimen should be clearly defined and mutually agreed upon by the parties.

1.2 This standard covers sample preparation, including the application of test coatings to wood substrates.

1.3 Valorile exprimate în unități SI sau unități inch-lire trebuie tratate separat ca valori standard. The values specified in each system are not necessarily the same; Prin urmare, to ensure compliance with the standards, each system should be used independently of each other and the values of the two systems should not be combined.

1.4 Acest standard nu este destinat să abordeze toate problemele de siguranță, dacă există, asociat cu utilizarea acestuia. Este responsabilitatea utilizatorului acestui standard să stabilească siguranța corespunzătoare, practicile de sănătate și de mediu și pentru a determina aplicabilitatea restricțiilor de reglementare înainte de utilizare.

1.5 Acest standard internațional a fost elaborat în conformitate cu principiile de standardizare recunoscute la nivel internațional stabilite în Decizia privind principiile pentru elaborarea standardelor internaționale., Orientări și recomandări emise de Comitetul pentru bariere tehnice în calea comerțului al Organizației Mondiale a Comerțului.