Semnificație și utilizare
5.1 This test method measures the cohesion strength of the adhesive on a pressure-sensitive product. Failure time can predict the end-use performance of pressure-sensitive products, such as edge leakage caused by cold flow; Finishing, slitting and die cutting quality; Tape stretching; Ability to seal packaging; And vertical retention.

5.2 The test method is suitable for quality control, development and application testing.

5.3 If the adhesive is not already applied, the adhesive may be applied to a smooth clear polyester (ANIMAL DE COMPANIE) film backing of 0.05 mm [0.002 în] grosime. The recommended dry glue thickness is 0.025 mm [0.001 în].

5.4 Humidity has a great influence on the failure time of many pressure-sensitive products. Prin urmare, humidity should be controlled according to 8.1.2.

ASTM D6463/D6463M-2020 Standard Test Method for Failure Time of Pressure-Sensitive Articles under Sustained Shear Loads

Etapa 1: Domeniul de aplicare
1.1 This test method covers the ability of pressure-sensitive products (de exemplu. tapes, labels, stickers, etc.) to maintain adhesion to stainless steel plates under a constant load applied parallel to the bonded surface of the pressure-sensitive product.

1.2 Values expressed in SI units or inch-pound units shall be regarded as standard values respectively. The values stated in each system may not be exactly the same, so each system needs to be used independently and cannot combine the values in any way.

1.3 This standard is not intended to address all safety concerns associated with its use. Este responsabilitatea utilizatorilor acestui standard să stabilească siguranța corespunzătoare, health and environmental specifications and to determine the applicability of regulatory restrictions prior to use.

1.4 Acest standard internațional se bazează pe principiile de standardizare recunoscute la nivel internațional stabilite în Decizia privind principiile pentru elaborarea standardelor internaționale., Guidelines and Recommendations issued by the WTO Technical Barriers to Trade (TBT) Committee.

ASTM D6463/D6463M-2020 Standard Test Method for Failure Time of Pressure-Sensitive Articles under Sustained Shear Loads

2. Refer to the file
ASTM standard

A666 Specification for annealed or cold worked austenitic stainless steel sheets, benzi, plates and flat steels

D907 adhesive terms

Test method for shear adhesion of D3654 / D3654M pressure sensitive tape

Width and length guide for D5750 / D5750M pressure sensitive tape

E171 Practice of adjusting and testing flexible barrier packaging

E177 Practice of using the terms accuracy and deviation in ASTM test methods

E691 Practice of conducting inter-laboratory studies to determine the accuracy of test methods