АСТМ Д 2457-2021 Standard Test Method for Specular Gloss of Plastic Films and Solid Plastics

Значење и сврха
4.1 Specular gloss is mainly used to measure the gloss appearance of films and surfaces. A precise comparison of gloss values is meaningful only if the same measurement procedure and the same general material type are involved. Нарочито, the gloss values of transparent films should not be compared with those of opaque films and vice versa. Glossiness is a complex property of surfaces that cannot be measured entirely by any single number.

4.2 Specular gloss usually varies with surface smoothness and flatness. It is sometimes used for comparative measurements of these surface properties.

АСТМ Д 2457-2021 Standard Test Method for Specular Gloss of Plastic Films and Solid Plastics

Обим
1.1 The test method describes procedures for measuring the glossiness of opaque and transparent plastic films and solid plastics. It contains four independent gloss angles (Белешка 1) :

1.1.160 степени, recommended for medium light films,

1.1.220 степени, recommended for high light film,

1.1.345 степени, recommended for medium and low light films,

1.1.485 степени, recommended for medium and low gloss films, as well

1.1.575 степени, recommended for plastic siding and soffit.

Белешка 1: The measuring devices and methods of 85 степени, 75 степени, 60 degrees and 20 degrees are repeated with those in test methods D523 and D3679; The equipment and methods for the 45° procedure were also taken from test method C346.

1.2 Овај стандард није намењен решавању свих безбедносних питања, ако их има, повезана са његовом употребом. Одговорност корисника овог стандарда је да успостави одговарајућу безбедност, здравствене и еколошке праксе и да се утврди применљивост регулаторних ограничења пре употребе.

АСТМ Д 2457-2021 Standard Test Method for Specular Gloss of Plastic Films and Solid Plastics

Белешка 2: There is no known ISO equivalent to this standard.

1.3 Овај међународни стандард је развијен у складу са међународно признатим принципима стандардизације утврђеним у Одлуци о принципима за израду међународних стандарда., Смернице и препоруке које је издао Комитет за техничке баријере у трговини Светске трговинске организације.

Дели овај пост