Before testing with the TABER wear testing machine, lift the test arm of the equipment, and then start the power supply for trial operation. From here, we can check whether the machine is working properly. Then lift the test arm and suction arm, remove the fixing nut and gasket (ring) of the specimen, and use the wrench to loosen the fixing screw of the fixing ring and pick up the fixing ring to complete this step. After stopping, the operator can use a small brush to remove the sand layer on the leather surface, here it needs to be noted that together with double-sided tape to remove the specimen, and then weigh with a precision scale, also for recording, counting to four decimal places, according to the formula to calculate the test value.

TABER wear-resistant testing machine can test natural leather, leather, PU, two kinds of leather, artificial leather, textile materials, glass, paint and other wear resistance test, the method is to take a diameter of 110mm circular sample according to the requirements, according to the relevant test standards with the corresponding load weight, set the corresponding test times, the machine will automatically stop when it reaches the set times. There is no need for personnel to stay for a long time, the instrument is controlled by the LCD screen, the operation is simple, convenient and safe, and the instrument is stable and does not beat when running.

TABER wear testing machine These 8 points must be kept in mind

TABER wear testing machine These 8 points must be kept in mind

1. The instrument must be placed on a stable ground before use.

2. When the instrument is abnormal, please contact the department for timely processing;

3. Select the corresponding power supply voltage, do not be too high, to avoid burning the device;

4. It is not allowed to handle the machine during use;

5. The machine must have a good ventilation environment when working.

6. After each test, clean the machine and keep the machine clean;

7. Key mechanical components, due to the large operating load, the mechanical part please add lubricating oil in time;

8. The control box should be wiped with dry cloth, not wet cloth.