Signification et objectif

5.1 À mesure que la résistance au pinceau de la peinture augmente, any natural tendency of the painter to overapply the paint will decrease. When all other factors are held constant, increasing brush resistance will result in greater film thickness, resulting in improved durability and concealment. On the contrary, it may sometimes be preferred to use a lesser degree of brush drag for easier application (c'est à dire., using a lesser degree of brush drag reduces the time and effort required to apply paint to a particular area).

5.2 This test method provides a standardized spawning procedure for assessing brush resistance as an alternative to the customary informal temporary procedure. The goal is to increase the reliability and precision of determining this feature as much as possible.

Note 1: Brush drag of paint is directly related to its high shear viscosity. There is generally good ranking order agreement between the results obtained by this method and the test method D4287. The sensitivity of this brushout method has been found to be sufficient to distinguish brush rates corresponding to high shear viscosity differences of not less than 0.3 poise (0.03 Pa.s). The cyclic data show that the ranking order agreement between the brush and viscosity methods is poor when latex and solve-based coatings belong to the same comparison group. This is due to the fact that the two paint types have significantly different rheological properties that can affect the relative perception of brush resistance. quatre

ASTM D4958-2016 “Comparaison de la brossabilité de la peinture au latex”

Champ d'application

1.1 This test method is a standardized brushing procedure for comparing brush resistance of architectural solvent-based coatings.

1.2 With slight modifications, this test method is also applicable to solvent-based coatings.

1.3 Les valeurs exprimées en unités SI doivent être considérées comme des normes. Les valeurs données entre parenthèses sont à titre indicatif uniquement.

1.4 Cette norme n'est pas destinée à traiter tous les problèmes de sécurité, si seulement, associé à son utilisation. Il est de la responsabilité des utilisateurs de cette norme d'établir des pratiques de sécurité et de santé appropriées et de déterminer l'applicabilité des restrictions réglementaires avant utilisation..