Arti dan Tujuan
5.1 The drying time of the coating is important to determine when it is possible to re-use a newly painted room, floor or staircase or to dispose of or package coated items. Slow drying may lead to dirt contamination or, on the exterior surface, kelembapan dapat menyebabkan tampilan tidak rata.

5.2 These test methods are used to determine the various stages of drying or curing during dry film formation of organic coatings using mechanical equipment to compare coating types or compositional changes, atau keduanya. To quantitatively assess the drying phase, the use of instruments under environmentally controlled conditions is highly recommended. These devices also provide a way to determine the drying characteristics of the coating that cannot be determined within a standard 8-hour working day.

5.3 When evaluating the drying characteristics of the baking system, the cyclic drying time equipment provides a method to determine the quantitative drying time of the coating at room temperature and high temperature conditions. The maximum temperature will be limited by factors such as the effect of temperature on motor lubrication or structural components of the equipment.

5.4 Linear drying time equipment provides a means of using a recorder to determine the quantitative drying time of simultaneously tested coatings.

5.5 This method can be used to compare the behavior of coatings during drying of the same general type. The actual drying time should be determined in accordance with the procedures outlined in Test Method D1640 or ISO 9117-3.

ASTM D 5895-2020 “Evaluasi Pengeringan atau Penggabungan Lapisan Organik selama Pembentukan Film dengan Perekam Mekanis”

Ruang lingkup
1.1 These test methods describe the determination of several stages and dry film formation rates of organic coatings using linear and circular mechanical drying time recording devices. The use of a mechanical recorder is valuable for comparing the drying behavior of the same generic type of coating, allowing one coating to form gel or resist tearing at a faster rate than another.

1.2 Drying times measured using mechanical recorders may differ from those using conventional methods such as test method D1640 or ISO 9117-3 (formerly known as ISO 1517).

1.3 The values specified in SI shall be regarded as standards. Nilai yang diberikan dalam tanda kurung hanya untuk referensi.

1.4 Standar ini tidak dimaksudkan untuk mengatasi semua masalah keselamatan, jika ada, terkait dengan penggunaannya. Pengguna standar ini bertanggung jawab untuk menetapkan keselamatan yang sesuai, praktik kesehatan dan lingkungan dan untuk menentukan penerapan pembatasan peraturan sebelum digunakan.

1.5 Standar internasional ini telah dikembangkan sesuai dengan prinsip-prinsip standardisasi yang diakui secara internasional yang ditetapkan dalam Keputusan Prinsip-Prinsip Pengembangan Standar Internasional, Pedoman dan Rekomendasi yang dikeluarkan oleh Komite Hambatan Teknis Perdagangan Organisasi Perdagangan Dunia.