ISO 787-1-1982 안료 및 충전제의 일반 시험 방법 – 부분 1: 안료 색상 비교

소개
ISO (국제 표준화기구) 국가 표준 협회의 글로벌 연맹입니다. (ISO 회원국). 국제 표준 개발은 ISO 기술위원회를 통해 수행됩니다.. 기술위원회가 설립된 주제에 관심이 있는 각 회원 기관은 해당 위원회에 대표될 권리가 있습니다.. ISO와 연락을 취하는 국제 정부 및 비정부 조직도 ​​이 작업에 참여합니다..

기술위원회에서 채택한 국제 표준 초안은 ISO 이사회에서 국제 표준으로 승인되기 전에 승인을 위해 회원국에 배포됩니다..

국제표준 ISO 787/1 기술위원회 ISO/TC에 의해 개발되었습니다. 35 (페인트 및 바니시) 6월 회원기관에 배포 1980.

ISO 787-1-1982 안료 및 충전제의 일반 시험 방법 – 부분 1: 안료 색상 비교

이는 다음 국가 회원 기관의 승인을 받았습니다.:

호주아일랜드폴란드
오스트리아이스라엘루마니아
브라질이탈리아남아프리카공화국
캐나다케냐스웨덴
중국대한민국스위스
이집트, 아랍공화국네덜란드영국.
인도고대 스칸디나비아 인소련

다음 국가의 회원국은 기술적인 이유로 문서에 대한 반대 의사를 표명했습니다.:

ISO 787-1-1982 안료 및 충전제의 일반 시험 방법 – 부분 1: 안료 색상 비교프랑스

독일, 정말로.

이 국제 표준은 ISO 권장 사항 R을 제거하고 대체합니다. 787/1-1968, 이는 기술적 개정을 구성합니다..

이 표준의 목적은 사양이 필요할 수 있는 개별 안료 및 충전재 전체 또는 다수에 적용할 수 있는 안료 및 충전재에 대한 공통 테스트 방법 세트를 확립하는 것입니다.. 이 경우, 안료 또는 충전제에 관한 국제 표준에는 일반적인 방법에 대한 상호 참조가 포함되어야 합니다., 해당 제품의 특정 특성을 고려하여 필요할 수 있는 세부적인 수정 사항을 표시합니다..

ISO/TC 35 기술위원회, 페인트 및 바니시, 전체 시리즈에 대한 각 방법의 관계를 강조하기 위해 가능한 경우 모든 일반적인 방법을 단일 국제 표준의 일부로 게시해야 한다고 결정했습니다..

ISO 787-1-1982 안료 및 충전제의 일반 시험 방법 – 부분 1: 안료 색상 비교

The Technical Committee also decided that if two or more procedures are widely used to determine the same or similar properties of pigments or fillers, there is no objection to the inclusion of more than one of these procedures in the ISO series. 이 경우, 하지만, you need to clearly state which method will be used in the specification and which method is used in the test report.

Published portions of the series are as follows:

부분 1: 안료 색상 비교

부분 2: 105°C에서 휘발성 물질 측정

부분 3: 수용성 물질의 결정 – hot extraction method

부분 4: Determination of acidity or alkalinity of water extracts

부분 5: Determination of oil absorption value

부분 7: Determination of residue on screensWater methodManual procedure

부분 8: 수용성 물질의 결정 – Cold extraction method

ISO 787-1-1982 안료 및 충전제의 일반 시험 방법 – 부분 1: 안료 색상 비교

부분 9: 현탁액의 pH 측정

부분 10: 밀도 결정 – 비중병 방식

부분 11: Determination of compaction volume and apparent density after compaction

부분 13: Determination of water-soluble sulfates, chlorides and nitrates

부분 14: Determination of the resistivity of water extracts

부분 15: Comparison of light fastness of similar types of colored pigments

부분 16: Relative coloring force (or equivalent coloring value) 그리고

Use automatic Muller to restore the color of linseed forest oil

부분 17: Comparison of flash power of white pigments

ISO 787-1-1982 안료 및 충전제의 일반 시험 방법 – 부분 1: 안료 색상 비교

부분 18: Determination of residue on screenswater methodmechanical flushing procedure

부분 19: Determination of water-soluble nitratessalicylic acid method

부분 20: Comparison of dispersabilityOscillation oscillation method

부분 21: Comparing the thermal stability of pigments using baking media

Chapter 22 Comparison of the resistance of pigments to osmosis

부분 23: 밀도 결정 (removal of ensnared air by centrifuge)

부분 24: Determination of the relative coloring power of colour pigments and the relative scattering power of white pigmentsphotometric method

0 소개
This document is part of ISO 787 “Common Test Methods for pigments and fillers”. ISO/R 787/1 was published in July 1968. The difference between this revision and the 1968 edition is this

ㅏ) The color comparison is performed using the procedure described in ISO 3668, 그리고

비) No adhesive is specified.

1 적용 범위 및 분야
1.1 ISO의 이 부분 787 specifies a common test method for comparing the color of colored pigments with the color of agreed samples.

1.2 Any of the procedures described in Article 6 are acceptable, but the method using the automatic Muller is the reference method.

ISO 787-1-1982 안료 및 충전제의 일반 시험 방법 – 부분 1: 안료 색상 비교

Note that when this general approach is applied to a given pigment, the international standard relating to that pigment should include only a cross-reference to that pigment and indicate any detailed modifications that may be required in view of the particular properties of the material concerned. A special method of color comparison should be specified only if the procedure given in this general method is not applicable to a particular material.

2 참고 자료
ISO 150, raw, 페인트 및 바니시용 정제 및 삶은 아마씨유 – 사양 및 테스트 방법.

ISO 842, 페인트 및 바니시 원료 – 견본 추출.

ISO 3668, 페인트 및 바니시 – 페인트 색상의 시각적 비교.

표준정보 부분만 공개. 전체 내용을 보시려면, 공식 채널을 통해 표준을 구매해야 합니다..

이 게시물을 공유하세요