Znaczenie i zastosowanie
4.1 This guide provides a useful summary of procedures for selecting and using test paint powders and powder coatings. It is suitable for thermoplastic and thermosetting coatings unless otherwise stated. By design, this guide is not intended to address test methods or procedures developed specifically for the functional powder coating market, tj., those powder coatings for pipes or reinforced steel bars (rebar). Information on current testing procedures for pipe and reinforced steel coating powders and powder coatings is available through their respective ASTM subcommittees A01.05 and D01.48.

4.2 Choosing the method to follow and the interpretation of the results will need to depend on the experience and requirements of each case, as well as the agreement between the buyer and the seller. It should be noted that many of the methods used to characterize paint powders, such as gel time (section 16) and inclined flow (Sekcja 17), are primarily used for the relative comparison of two paint powders rather than giving test values that can be interpreted as good or bad. Interpretation of test results will depend on the specific application in question and often also on the chemical properties of the paint powder used.

ASTM D3451-06-2017 “Badanie powłok proszkowych i powłok proszkowych”

zakres
1.1 This guide covers the selection and use of procedures for testing paint powders and powder coatings. Tabela 1 lists the included test methods. If more than one test method is listed for the same feature, no attempt is made to show that one method is superior to the other. Choosing the method to follow needs to depend on the experience and requirements of each case, as well as the agreement between the buyer and the seller.

1.2 This guide also references methods developed specifically for the coating powder industry by the Powder Coatings Council (PCI) and the International Standards Organization (ISO).

1.3 This guide describes the testing of paint powders by electrostatic spraying, fluidized bed or any other applicable method.

1.4 Wartości wyrażone w jednostkach SI należy traktować jako wartości standardowe. Norma ta nie obejmuje innych jednostek miar.

1.5 Celem tej normy nie jest uwzględnienie wszystkich, Jeśli w ogóle, obawy dotyczące bezpieczeństwa związane z jego użytkowaniem. Obowiązkiem użytkowników niniejszej normy jest ustanowienie odpowiednich praktyk w zakresie bezpieczeństwa i higieny pracy oraz określenie możliwości zastosowania ograniczeń regulacyjnych przed użyciem.

1.6 Niniejsza norma międzynarodowa opiera się na uznanych na arenie międzynarodowej zasadach normalizacji, ustanowionych w Decyzji w sprawie zasad opracowywania norm międzynarodowych, Wytyczne i zalecenia wydane przez Komitet WTO ds. Barier Technicznych w Handlu.