Znaczenie i cel
4.1 – most commonly coating thickness gauge does not apply to all the combination of base material thickness and material. The limitations of a particular instrument is usually described by their manufacturers. In choosing to use the instrument and the required accuracy of measurement, should be examined to measure the substrate material and coating combination and the change of substrate and coating.

4.2 Magnetic – The magnetic type measuring instrument measures the magnetic force between the magnet and the coating or its substrate, or the reluctance of the magnetic flux path through the coating and the substrate. These thickness gauges are designed to measure the thickness of non-magnetic coatings on magnetic substrates. Some of them will also measure the thickness of nickel coatings on magnetic or non-magnetic substrates. 6

4.3 Eddy Current – The eddy current type thickness gauge is an electronic instrument used to measure the impedance change of the eddy current induction coil caused by the change of coating thickness. Only when the electrical conductivity of the coatings and the conductivity of the substrate is obviously not at the same time, in order to use them.

4.4 Precyzja – The accuracy of the measurement depends on the instrument, the foil, its calibration and standardization, and the operating conditions. Accuracy is also affected by the interference of listed in section 5, such as part geometry (curvature), magnetic permeability and electric conductivity, and surface roughness.

Notatka 2: Under ideal conditions, the coating thickness can be determined to within ±10% of its true thickness or ±2.5μm (or ±0.0001 in), whichever is greater. See Appendix X2 for exceptions.

Determination of Coating Thickness by Magnetic Field Method or Eddy Current Method (Metoda pola elektrycznego)

Zakres
1.1 this practice include the use of magnetic and type eddy current thickness instrument (miernik) of the coating on metal (tj., przewodzący) substrate nondestructive thickness measurement. The substrate can be ferrous or non-ferrous metal. The coating or plating under test can be conductive or insulating, ferrous or non-ferrous metals.

1.2 The more specific use of these instruments is covered by Practice D7091 and the following test methods published by ASTM: Test Methods B244, B499 and B530.

1.3 jednostki – values in SI units shall be deemed to be standard. Values given in the brackets are inches – pound unit mathematical transformation, wyłącznie w celach informacyjnych, not be regarded as standard.

1.4 according to the practice of measurement to accord with the requirement of printing of ISO 2178 W 1982.

1.5 niniejsza norma nie ma na celu rozwiązywania związanych z jej stosowaniem wszelkich kwestii związanych z bezpieczeństwem (Jeśli w ogóle). Obowiązkiem użytkownika niniejszej normy jest zapewnienie odpowiedniego bezpieczeństwa, praktyk zdrowotnych i środowiskowych oraz w celu określenia możliwości zastosowania ograniczeń regulacyjnych przed użyciem.

1.6 tym międzynarodowym standardem są bariery techniczne w handlu, zgodnie z wydanym przez Komitet Światowej Organizacji Handlu “o ustalaniu międzynarodowych standardów, wytyczne i zalecenia decyzji o zasadzie” ustanowienie uznanych na arenie międzynarodowej zasad normalizacji.