ASTM D7539 Standard Practice for Humidity Regulation of Pavement Marking Coatings test Boards using a laboratory defines a standard environment with a temperature of 23±2°C, a relative humidity of 50± 5%, and no airflow for the normal regulation and testing of paints, лакови, lacquers, and related materials.
Значење и употреба

5.1 The drying rate of organic coatings varies with temperature, air flow and relative humidity. Нарочито, the drying rate of water-based coatings depends on the evaporation of water and is therefore more dependent on relative humidity than solvent-based coatings or 100% solid coatings. Without some control over drying conditions, the drying rate of water-based coatings measured in the laboratory under ambient conditions cannot be adequately replicated. A test chamber providing a device for controlling relative humidity above ambient humidity and minimizing the effect of changes in airflow at ambient room temperature is described. If needed,

5.2 This practice is particularly useful for testing the drying rate of waterborne pavement marking (traffic) премази, where rapid drying at high ambient humidity is an important feature. For waterborne traffic coatings, test chambers can be used to assess dryness to non-absorption at high ambient humidity (test method D711) and washable resistance (practice D7377 and D7538).

ASTM D7539-2015 Standard Practice for Humidity Regulation of Pavement Marking Coatings Test Boards Using Laboratories

Корак 1: Обим

1.1 Specification D3924 defines a standard environment with a temperature of 23±2°C, a relative humidity of 50± 5% and no airflow for the normal conditioning and testing of paints, лакови, lacquers and related materials. The practice describes a test chamber that allows the control of relative humidity above the ambient relative humidity and minimizes air flow to regulate the test board at elevated relative humidity and room temperature.

1.2 Вредности у инчима у фунте ће се сматрати стандардним вредностима. Вредности дате у заградама су математичке трансформације СИ јединица и служе само за референцу и не сматрају се стандардним.

1.3 Овај стандард није намењен да реши све безбедносне проблеме, ако их има, повезана са његовом употребом. Одговорност корисника овог стандарда је да успоставе одговарајуће безбедносне и здравствене праксе и да утврде применљивост регулаторних ограничења пре употребе.