Значење и употреба

3.1 Since the pipe coating is subject to concentrated pressure exerted by the weight of the pipe and the backfill, this test is mainly used to determine the resistance of the coating to penetration or deformation under controlled conditions.

3.1.1 If the coating is not penetrated, the deformation of the compressible coating does not indicate a potential defect in the underground burial service. Deformation is not comparable to penetration coating.

АСТМ Г17-07-2020 “Стандардна метода испитивања отпорности премаза цеви на пропусност (Блунт Родс)”

Обим

1.1 This accelerated test method is used to determine the relative resistance of steel pipe coatings to penetration or deformation of blunt rods under specified loads. This test method is applicable to the test of all kinds of non-metallic pipe coatings under various temperatures.

1.2 The value of three significant decimal places in SI units shall prevail. Вредности дате у заградама су само за референцу.

1.3 Овај стандард није намењен решавању свих безбедносних питања, ако их има, повезана са његовом употребом. Одговорност корисника овог стандарда је да успоставе одговарајућу безбедност, health, and environmental practices and to determine the applicability of regulatory restrictions prior to use.

АСТМ Г17-07-2020 “Стандардна метода испитивања отпорности премаза цеви на пропусност (Блунт Родс)”

1.4 This international standard is developed in accordance with the internationally recognized standardization principles established in the decisions on International Standards, Guidelines and Recommended Principles issued by the WTO Technical Barriers to Trade (ТБТ) Комитет.