Abstract
This specification covers a pressure-sensitive tape for sealing and sealing slip-top containers, such as fibre tubes and metal cans. Mylar back pressure sensitive tape is designed to be used for sealing and sealing containers with sliding LIDS, such as spiral wound pipes and metal cans, where strength, water resistance, water vapor resistance and rain resistance and other deterioration factors are required. The tape shall meet the specified physical performance requirements. The following test methods shall be performed to meet the specified requirements: adhesion; Shear adhesion tensile thickness; Relax; Water permeability; Water vapor transmittance; And accelerate aging.

This summary is a brief summary of the reference standards. It is informational only and not a formal part of the standard; The full text of the standard itself needs to be used and applied for reference. ASTM provides no warranties, express or implied, and does not represent that the content of this abstract is accurate, complete, or new.

ASTM D6590/D6590M-2020 Standard Specification for Pressure Sensitive Tape for Sealed Fiber Containers and Tanks

Step 1: Scope
1.1 This specification covers a pressure-sensitive tape for sealing and sealing slip-top containers, such as fibre tubes and metal cans.

1.2 Values expressed in inch-pounds or SI units shall be treated as standards separately. The values specified in each system may not be exactly the same; Therefore, each system needs to be used independently and the values cannot be combined in any way.

1.3 The following safety hazard warnings apply only to the Test Methods section of this specification: This standard is not intended to address all safety hazards associated with use. It is the responsibility of users of this standard to establish appropriate safety, health and environmental specifications and to determine the applicability of regulatory restrictions prior to use.

1.4 This international standard is based on internationally recognized standardization principles established in the Decision on Principles for the Development of International Standards, Guidelines and Recommendations issued by the WTO Technical Barriers to Trade (TBT) Committee.

ASTM D6590/D6590M-2020 Standard Specification for Pressure Sensitive Tape for Sealed Fiber Containers and Tanks

2. Refer to the file
ASTM standard

D996 Packaging and distribution environmental terms

Test method for peel adhesion of D3330 / D3330M pressure sensitive tape

D3611 pressure sensitive tape accelerated aging practice

Test method for thickness of D3652 / D3652M pressure sensitive tape

Test method for shear adhesion of D3654 / D3654M pressure sensitive tape

D3715 / D3715M pressure sensitive tape quality assurance practice

Test method for breaking strength and elongation of D3759 / D3759M pressure sensitive tape

Test method for unwinding force of D3811 / D3811M pressure sensitive tape

Test method for water permeability of D3816 / D3816M pressure sensitive tape

Test method for water vapor transmittance of D3833 / D3833M pressure sensitive tape

D3951 Commercial packaging specification

D5570 used as a test method for water resistance of tapes and adhesives for box covers

ISO standard

ISO 9002