ASTM D 2457-2021 Standard Test Method for Specular Gloss of Plastic Films and Solid Plastics

Význam a účel
4.1 Specular gloss is mainly used to measure the gloss appearance of films and surfaces. A precise comparison of gloss values is meaningful only if the same measurement procedure and the same general material type are involved. Zejména, the gloss values of transparent films should not be compared with those of opaque films and vice versa. Glossiness is a complex property of surfaces that cannot be measured entirely by any single number.

4.2 Specular gloss usually varies with surface smoothness and flatness. It is sometimes used for comparative measurements of these surface properties.

ASTM D 2457-2021 Standard Test Method for Specular Gloss of Plastic Films and Solid Plastics

Pohled do
1.1 The test method describes procedures for measuring the glossiness of opaque and transparent plastic films and solid plastics. It contains four independent gloss angles (Poznámka 1) :

1.1.160 stupně, recommended for medium light films,

1.1.220 stupně, recommended for high light film,

1.1.345 stupně, recommended for medium and low light films,

1.1.485 stupně, recommended for medium and low gloss films, as well

1.1.575 stupně, recommended for plastic siding and soffit.

Poznámka 1: The measuring devices and methods of 85 stupně, 75 stupně, 60 degrees and 20 degrees are repeated with those in test methods D523 and D3679; The equipment and methods for the 45° procedure were also taken from test method C346.

1.2 Tato norma není určena k řešení všech bezpečnostních problémů, jestli nějaký, spojené s jeho užíváním. Je odpovědností uživatele této normy zajistit odpovídající bezpečnost, zdravotní a environmentální postupy a určit použitelnost regulačních omezení před použitím.

ASTM D 2457-2021 Standard Test Method for Specular Gloss of Plastic Films and Solid Plastics

Poznámka 2: There is no known ISO equivalent to this standard.

1.3 Tato mezinárodní norma byla vyvinuta v souladu s mezinárodně uznávanými normalizačními zásadami stanovenými v Rozhodnutí o zásadách pro vývoj mezinárodních norem., Směrnice a doporučení vydané Výborem pro technické překážky obchodu Světové obchodní organizace.

Sdílet tento příspěvek