ASTM D2486-2017 Standard Test Method for Scrubbing Resistance of Wall Coatings
Anlamı ve kullanımı
4.1 Boya sıklıkla lekelenir, özellikle kapıların yakınında, pencereler, ve çalışma ve oyun alanları. These test methods cover the determination of the relative resistance of different paints to erosion when repeatedly scrubbed during the life of the paint.
4.2 Test Method D4213 is a similar scrubbing resistance test that uses weight loss techniques and reports volume film erosion rates.
4.3 Test Method A The scrubbing resistance is measured using the traditional cycle failure concept. The poor correlation in scrubbing tests can be attributed to changes in bristle stiffness, washability tester status, application, and drying conditions. To improve reproducibility, test Method B has been developed.
ASTM D2486-2017 Standard Test Method for Scrubbing Resistance of Wall Coatings
Yarıçap
1.1 These test methods cover procedures for determining the resistance of wall coatings to erosion caused by scrubbing, herein referred to as “scrubbing resistance”.
1.2 Covers the following two test methods:
1.2.1 Test Method A – Failure period obtained on test coatings.
1.2.2 Test Method B – Ratio expressed as a percentage of the period obtained with the test coating and the period and failure period obtained while running with a known reference coating.
1.3 SI birimlerinde ifade edilen değerler standart kabul edilecektir.. Parantez içinde verilen değerler yalnızca referans amaçlıdır.
1.4 Bu standardın tüm güvenlik konularını ele alması amaçlanmamıştır., varsa, kullanımıyla ilgili. Uygun güvenlik ve sağlık uygulamalarını oluşturmak ve kullanımdan önce düzenleyici kısıtlamaların uygulanabilirliğini belirlemek bu standardı kullananların sorumluluğundadır..
1.5 Bu uluslararası standart, Uluslararası Standartların Geliştirilmesine İlişkin İlkeler Kararında belirlenen uluslararası kabul görmüş standardizasyon ilkelerine dayanmaktadır., DTÖ Ticaretin Önündeki Teknik Engellere İlişkin Komite tarafından yayınlanan Kılavuzlar ve Tavsiyeler.